Oshawa Scissor Lift Certification

Oshawa Scissor Lift Certification - Scissor lift platforms are utilized at work places in order to enable tradespeople - like for instance iron workers, welders and masons - to reach their work. Utilizing a scissor lift platform is typically secondary to their trade. Thus, it is important that all platform operators be correctly trained and licensed. Industry, lift manufacturers and regulators work together in order to make sure that operators are trained in safely utilizing work platforms.

Work platforms are also referred to as manlifts or AWPs. These equipment are stable and simple to operate, even if there is always some danger as they lift people to heights. The following are some key safety concerns common to AWPs:

There is a minimum safe approach distance (also known as MSAD) for all platforms in order to protect from accidental discharge of power because of proximity to power lines and wires. Voltage could arc across the air and cause injury to personnel on a work platform if MSAD is not observed.

Care should be taken when lowering a work platform to guarantee steadiness. The boom should be retracted, when you move the load toward the turntable. This would help maintain stability in lowering of the platform.

Rules do not mandate those working on a scissor lift to tie off. Then again, personnel might be needed to tie off if needed by employer guidelines, local regulations or job-specific risk assessment. The anchorage provided by the manufacturer is the only safe anchorage to which lanyard and harness combinations must be attached.

Observe the maximum slope rating and do not exceed it. A grade can be measured by laying a straight edge or board on the slope. Next, a carpenter's level can be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the length of the straight edge, then multiplying by 100, the per cent slope can be determined.

A regular walk-around check should be done to determine if the unit is mechanically safe. A site assessment determines if the work place is safe. This is important particularly on changing construction locations because of the chance of obstacles, unimproved surfaces, and contact with power lines. A function test must be performed. If the unit is utilized correctly and safely and correct shutdown procedures are followed, the possibilities of incident are greatly reduced.

Click to Download the pdf